Laddar
Laddar
Laddar
Generic Application Error Test JSP (Item)

The store has encountered a problem processing the last request. Try again later. If the problem persists, contact your site administrator.



Generic Application Error Test JSP (Item)

The store has encountered a problem processing the last request. Try again later. If the problem persists, contact your site administrator.



Product image
  • Laddar
  • Laddar
  • Laddar

CONCRETE SCREW ECS-W, WAF HEAD, BRIGHT ZINC PLATED

CONCRETE SCREW ECS-W, WAF HEAD, BRIGHT ZINC PLATED



Description
  • Area of usage

    ESSVE Concrete screw designed for quick and easy fixing in concrete, brick, hollow block and hollow brick.

  • Description

    Specially hardened screw that is can be screwed directly into a drilled hole without a plug. It is fully threaded with a
    “hi-lo” thread which facilitates installation. The screw is produced in hardened carbon steel with bright zinc plated
    or CorrSeal surface treatment. Generally, the loading capacity is improved by increasing the fixing depth. For
    fixing in materials other than concrete a pull-out test should be made according to the evaluation method
    approved by Boverket, (The Swedish National Board of Housing, Building and Planning) to produce an applicable practical load bearing capacity. The concrete screw is also tested and approved
    for pulsating loads.


  • Assembly

    When mounting, an impact screwdriver is recommended. See installation instructions.

    The concrete screw does not require a preload torque to ensure the fixing, which means that when the screw has reached the surface, all tightening must be avoided. The final torque applied shall not be greater than that required to hold what is to be fixed in place. The tightening torque specified is the maximum torque, not to be confused with other products that require a preload operation.

    The ECS concrete screw is through hardened and therefore sensitive to oblique mounting. The bore shall be 90 degrees to the substrate.

    ESSVE ECS Concrete Screw has no requirement for blowing of borehole before installation, but the borehole must be deep enough to assemble the Concrete screw in along with the dust that is left behind. Otherwise, the screw will not be mounted to the right depth. ESSVE ECS Concrete Screw has no requirement for purging of borehole before installation, but the bore must be deep enough to assemble the Concrete screw in along with the dust that is left behind. Otherwise, the screw will not be mounted to the right depth.

Items
Fetching article information