LIFTING EYE LT, THREADED STUD, DIN 580, HOT DIP GALVANIZED

Lifting eye screw LT is designed according to DIN 580. LH according DIN 582. Made of hardened steel with hot dip galvanized surface treatment for outdoor use.

Read more about this product

General

  • Corrosion resistance classC3
  • Surface treatmentHot Dip Galvanized
  • Application environmentOutdoors
  • StandardsDIN 580

Description

Lifting eye screw LT is designed according to DIN 580. LH according DIN 582. Made of hardened steel with hot dip galvanized surface treatment for outdoor use.

Assembly

Lifting eye screws are to be screwed down hard against the substrate. When two lifting eye screws are used, their interrelated position must be such that the eyes lie on the same plane. As they must be tightened firmly against the substrate, it may be necessary to place washers between the flange and the substrate to ensure the eyes are on the same plane. Angles greater than 90º between the lifting slings are not permitted. Installation must not be carried out against a plane that significantly deviates from a plane perpendicular to the lifting direction straight up. Max. permitted load only applies for lifting eyes designed according to the given standard and if installation is performed as set out above. See more information in Technical data, table 13.

Item numberEANNamePackagePackage contentsBV
610910257317761223665LIFTING EYE BOLT M8 HDG1 á 10 ST
610910257317761831365LIFTING EYE BOLT M8 HDG12 á 10 ST
610910277317761223672LIFTING EYE BOLT M10 HDG1 á 10 ST
610910277317761831372LIFTING EYE BOLT M10 HDG8 á 10 ST
610910297317761223689LIFTING EYE BOLT M12 HDG1 á 10 STOBSOLETE
610910297317761831389LIFTING EYE BOLT M12 HDG6 á 10 STOBSOLETE
610910317317761223696LIFTING EYE BOLT M16 HDG1 á 10 ST
610910317317761831396LIFTING EYE BOLT M16 HDG4 á 10 ST